Axis 247S Manual de usuario descargar pdf (Pagina 18)

AXIS 247S - Event Configuration

Event Configuration

This section describes how to configure the Video Server for alarm handling. Various actions can be configured

to run when certain types of events occur.

A set of parameters describing how and when the Video Server is to perform certain actions

- the circumstances that start an event e.g. at a signal from an external device, such as a door switch or a motion sensor

- the circumstances that start an event e.g. at a pre-programmed time

- what occurs when the event runs e.g. video images uploaded to an FTP server, email notification sent, etc.

Event Servers

Event Servers are used for e.g. receiving uploaded image files and/or notification messages. To set up an Event

server for your Video Server, go to Setup > Event Configuration > Event Servers and enter the required

information according to the selected server type.

For details on each setting, please refer to the online help available from each web page.

Note: Pre-trigger and Post-trigger buffers will be lost if the connection to the event server fails.

When the setup is complete, the connection can be tested by clicking the Test button (the connection test takes

approximately 10 seconds).

An event in the AXIS 247S is when a trigger is activated, causing a certain action to be performed. The event

is the set of parameters (or conditions) that specifies how and when which actions will be performed. A

common event is when an Input/output is activated when triggered by an alarm.

This section describes how to configure the AXIS 247S to perform certain actions when an event (e.g. an

alarm) occurs.

Event type

Triggered Event (see page 19)

Scheduled Event (see page 20)

Action

Server type Purpose Information required

FTP Server • receives uploaded images • Descriptive name of your choice

• User Name and Password (to FTP server)

• Upload path, e.g. images/

• Port number

• Use passive mode if there is a firewall between the Video Server and FTP server

• Use temporary file if your FTP server doesn’t allow an existing file to be overwritten

by a new file with the same name.

HTTP Server • receives uploaded images

• receives notification messages

• Descriptive name of your choice

•URL (address)

• User Name and Password (to HTTP server)

• Proxy address/Proxy port (if required)

• Proxy User Name and Password (if required)

TCP Server • receives notification messages • Descriptive name of your choice

• User Name and Password (for TCP server)

• Port number

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Comentarios a estos manuales

Sin comentarios

Axis 247S Manual de usuario Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Axis 247S