Axis 7000 Guía de usuario descargar pdf (Pagina 9)

AXIS 7000 User’s Guide Basic Installation

Connecting Digital Copiers and Scanners

Caution!

1. Switch off the scanning device and disconnect the AXIS 7000 external power

supply.

2. Connect the SCSI cable to the SCSI connector on the AXIS 7000.

3. Connect the SCSI cable to the scanning device. The AXIS 7000 uses a built-in

SCSI terminator. Note that the scanning device must also be terminated properly.

Refer to the documentation supplied with your scanning device.

Connecting the AXIS 7000 to the Network

1. Connect your AXIS 7000 to the network.

Note:

2. Switch on the scanning device.

3. Connect the external power supply to the AXIS 7000. The network indicator will

flash during power up and self test. The following message will appear on the

display during self test:

where x.xx is the software version number, e.g. 2.10

Note:

• Check that the power supply included with your AXIS 7000 is marked with the correct mains

voltage.

• Make sure that the scanning device and the AXIS 7000 are switched off. The SCSI bus may

become damaged if you connect or disconnect units when power is on.

The AXIS 7000 is designed for 10 Mbps Ethernet and 100 Mbps Fast Ethernet networks and

connects to the network via a twisted pair category 5 cable (10baseT and 100baseTX)

AXIS 7000

Version: x.xx

The tri-colored Network indicator flashes:

• yellow - indicating network activity on a 10MB Ethernet network.

• green - indicating network activity on a 100MB Fast Ethernet network.

• red -indicating that the unit is not correctly connected to the network.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 24 25

Sin comentarios

Axis 7000 Guía de usuario Pagina 9