Axis 241Q Guía de instalación descargar pdf (Pagina 5)

AXIS 241Q/S Blade - Rack Solution Installation Guide

Bus Connector

Physical interface to the I/O Block Connector on the rack. See the

illustration.

DIP Switch(es)

A corresponding line termination switch for each of the

supported video outputs (1-4 video outputs depending on the

model).

• All units are shipped with the line termination enabled for

each supported video input; that is, with the DIP switches set

to ON (Down position). See the illustration.

•If the AXIS 241Q Blade is to be connected in parallel with

other equipment, disable the input termination by setting the

corresponding DIP switch to OFF (Up position). Failure to do

this can cause the picture quality to be impaired.

•The AXIS 241S is delivered configured for composite video

input:

Axis Video Server Rack

The I/O Terminal Block

The physical interface to a relay switch output and four digital photo-coupled inputs; also providing an RS-485

interface and an RS-232 serial connection.

Network Connector

Axis blade video servers are designed for 10 Mbps Ethernet /100 Mbps Fast Ethernet networks and connect to

the network via a standard RJ 45 connector.

DC + Power 12VDC Power (output)

This connector can drive the photo coupler inputs or other equipment such as an IR-sensor. A maximum

current (for all pins) of 1000mA can be sourced from the DC output.

Power Connector

Input power: 100-240 VAC, 50-60 Hz, 1.6A.

Switch Description

75 ohm video in termina-

tion

75 ohm video

out termination

connects video in and

video out

not used

Composite video input on off on n/a

Y/C video input on on off n/a

I/O Terminal

Blocks

Network

Connectors

DC-Power

(GND)

Power

Connector

DC+Power

Bus

Connector

DIP Switch(es)

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

Axis 241Q Guía de instalación Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Axis 241Q