Axis AXIS USB Manual de usuario descargar pdf (Pagina 11)

SINGLE INPUT: Both axis limit switches are connected to one pin.

Direction of travel determines if positive or negative switch is triggered.

LIMIT 1: Axis 1 negative and positive limit

LIMIT 2: Axis 2 negative and positive limit

LIMIT 3: Axis 3 negative and positive limit

LIMIT 4: Axis 4 negative and positive limit

LIMIT 5: Axis 5 negative and positive limit

LIMIT 6: Axis 6 negative and positive limit

LIMIT 7: Axis 7 negative and positive limit

LIMIT 8: Axis 8 negative and positive limit

SHIFT: Axis 9 negative and positive limit

GND: Ground connections

NOTE: If 'normally open' (NO) type switches are used, wiring must be done in parallel method, if

'normally closed' (NC) type switches are used, wiring must be done in serial method.

Software 'Invert' options allow use of ‘normally closed’ or ‘normally open’ switch hardware. This feature

can be set in File/Settings/Limit/Invert

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

Sin comentarios

Axis AXIS USB Manual de usuario Pagina 11