Axis P5512 PTZ Guía de instalación descargar pdf (Pagina 9)

AXIS P5512-E Installation Guide Page 9

ENGLISH

Install the network camera

1. Install the selected bracket (not

included) according to the

instructions supplied with the

bracket. If drilling is required,

make sure to use drill bits,

screws, and plugs that are

appropriate for the material.

See www.axis.com for informa-

tion on available mounting

accessories.

2. Route the network cable and

attach the supplied RJ45

connector. Refer to the

instructions provided with the

connector for information on

wiring and assembly.

3. Hook the camera to the safety wire on the bracket.

4. Connect the network cable and RJ45 connector to the network connector on the camera.

5. Check that the indicator LEDs on the midspan indicate the correct conditions. See the table on

page 10 for further details.

6. Slide the unit holders on the camera into the slots on the bracket and rotate the camera unit.

7. Secure the network camera to the mounting bracket by fastening the 3 screws (Torx T30).

IMPORTANT!

The supplied RJ45 connector or a compatible, IP66 rated RJ45 connector must be used in order to

comply with the IP66-rated design of the camera.

Wall bracket (mounting example, bracket not included)

Safety

wire

Slots for

Screws

Torx T30

unit holders

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 91 92

Sin comentarios

Axis P5512 PTZ Guía de instalación Pagina 9