Axis 7100 Especificaciones descargar pdf (Pagina 20)

Greasing Procedures

Advanced Dicing Technologies Ltd.

3.4-6

3.4.3.1 Removing the Old Grease from the Y and Z Axes

On a quarterly basis, the old grease should be removed from the Y and

Z Axes before applying new grease.

To Remove the Old Grease from the Y and Z Axes:

1 In the Video Workspace, click and hold the down arrow (in the group of

arrows on the right of the Workspace) until the Z Axis reaches its

lowest position.

2 Open the Front Clear Cover.

3 Remove the eight screws (2 on front, 4 on top, 2 on back) that secure

the Z Casting Cover and remove the Cover.

4 Remove the four Y Bellows Cover screws and move the Bellows to one

side.

5 Remove the old grease from the Leadscrew using waste paper.

6 Grease the Y and Z Axes, as described in section 3.4.3.

7 Re-attach the Y Bellows to the Y Bellows Cover, using the screws

previously removed.

8 Re-attach the Z Casting Cover, using the eight screws previously

removed.

9 Close the hinged Spindle Cover.

1 Screws on Z

Cover (6 of 8)

2 Y Bellows Cover

3 Camera Cover

Figure 3-6: Z Casting Cover

1 2 ... 15 16 17 18 19 20

Sin comentarios

Axis 7100 Especificaciones Pagina 20