8 of 9
g! CONFIGURATION DETAILS
The following table provides settings used in the g! Configurator. Please refer to the Configurator Reference Guide for more details.
In the table below:
o “<Select>” Select the appropriate item from the list (or drop-down) in the Configurator.
o “<User Defined>”, etc. Type in the desired name for the item.
o “<Auto Detect>”, etc. The system will auto detect this variable.
Devices Variable Name Setting Comments
Communication Device N/A (See Note 1)
N/A (
See Note 1
)
Video Cameras/Sources Name
<User Defined>
Device Type Axis MODEL Port
Select appropriate MODEL
IP Address
<User Defined> (Default:
192.168.0.80
) (See Note 2)
Port 80
Typically left at 80. Cameras do not need to be set to different listening ports for g!
Settings
<Select> (Default: <1>) Choose desired port number or quad view for 4 port servers
UserName
<User Defined> (Default:
root
)
Pa ssw ord
<User Defined> (Default:
root
)
Enable DVR
<Select> (Default:<
No
>) Set to YES to enable the built in DVR function. See the DVR Integration Note for full details.
Flip Image 180
<Select> (Default: <
No
>) Set to YES if camera is inverted.
Hide Resolution Control
<Select> (Default: <
No
>) Set to YES to hide the Resolution control buttons from the Viewer.
Hide Full Screen Control
<Select> (Default: <
No
>) Set to YES to hide the Full Screen button from the Viewer.
Default Resolution
<Select> (Default: <
Auto
>) Set to desired Default Resolution: the camera will always load at this setting when viewed.
Record Resolution
<Select> (Default: <
Don't Change
>) Don't Change will default to last active resolution, or set a specific resolution for recording.
Record Mode
<Select> (Default:
Auto (Medium Sensitivty)
) Select the desired sensitivity level for the Auto motion mode, or choose fixed value.
Record Threshold
<Select> (Default: Disabled) Record Mode must be set to "Fixed Threshold" to enable. Select the desired motion %
Event-Map Motion Trigger
<Select> (Default: Disabled)
Set to enable Motion Detection as a Event Map trigger. This is not required for typical DVR
function, and is only needed if you wish to use the Motion % as a Event trigger.
Trigger Value
<Select> (Default:
50%
) Set the level for the Event Map motion detection trigger. Lower is more sensitive.
Notes:
1. No Communication Device is needed: just add Video Ports.
2. By default, set the first IP Video device is set to 192.168.0.80, the second to 192.168.0.81, and so on.
(64 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales