Axis QIG5800 Manual de usuario descargar pdf (Pagina 2)

Step

Connect the Hardware

1. Make sure that the printer is switched off and that the power supply is disconnected from

the AXIS 5800 Mobile.

2. Locate the serial number, found on the underside label of the AXIS 5800 Mobile, and write

it down. You can use this number to set the IP-address of the print server. Example: Ser.

No. 00408C1802FB

3. Connect your printer(s) to the print server’s LPT1 or LPT2 port using a printer cable. Make

sure the Bluetooth antenna is pointing towards the ceiling.

4. Connect your AXIS 5800 Mobile to your network (Ethernet Connector), using a twisted pair

category 5 cable

5. Switch on your printer(s) and make sure the printer is ready for use.

6. Connect the power supply to the Power Supply Connnector. The Network Indicator will

start flashing when the print server is correctly connected to the network.

7. Wait 1 minute and press the test button once. A test page will be printed on the connected

printer, keep it handy during the installation. The test page will show the IP address of the

print server.

LPT1

LPT2

Power Supply Connector

Test Button

Bluetooth

Antenna

Network Indicator

Power Indicator

Ethernet

(10 base &

100 base TX)

Connector

1 2 3 4 5 6 7 ... 12 13

Sin comentarios

Axis QIG5800 Manual de usuario Pagina 2