Axis M7001 Manual de usuario descargar pdf (Pagina 7)

AXIS M7001 - Using the Video Encoder

Access from the Internet

Once connected, the video encoder is accessible on your local network (LAN). To access the video encoder from the Internet

you must configure your broadband router to allow incoming data traffic to the video encoder. To do this, enable the

NAT-traversal feature, which will attempt to automatically configure the router to allow access to the video encoder. This is

enabled from Setup > System Options > Network > TCP/IP Advanced.

For more information, please see NAT traversal (port mapping) for IPv4, on page 30. See also the AXIS Internet Dynamic DNS

Service at www.axiscam.net For Technical notes on this and other topics, visit the Axis Support web at www.axis.com/techsup

Setting the root password

To gain access to the product, the password for the default administrator user root must be set. This is done in the ‘Configure

Root Password’ dialog, which is displayed when the video encoder is accessed for the first time. To prevent network

eavesdropping, the root password can be set via an encrypted HTTPS connection, which requires an HTTPS certificate.

Note:

HTTPS (Hypertext Transfer Protocol over SSL) is a protocol used to encrypt the traffic between web browsers and serv-

ers. The HTTPS certificate controls the encrypted exchange of information.

To set the password via a standard HTTP connection, enter it directly in the Configure Root Password dialog.

To set the password via an encrypted HTTPS connection, follow these steps:

1. Click the Create self-signed certificate button.

2. Provide the requested information and click OK. The certificate is created and the password can now be set

securely. All traffic to and from the video encoder is encrypted from this point on.

3. Enter a password and then re-enter it to confirm the spelling. Click OK. The password has now been configured.

Notes:

• The default administrator user name ‘root’ is permanent and cannot be deleted.

• If the root password is lost, the video encoder must be reset to the factory default settings, see page 34.

• If prompted, click Yes to install the AXIS Media Control, which allows viewing of the video stream in Internet

Explorer. You will need administrator rights on the computer to do this.

To configure the password

directly via an unencrypted

connection, enter the password here.

To create an HTTPS connection,

start by clicking this button.

1 2 3 4 5 6 7 8 9 10 11 12 ... 45 46

Sin comentarios

Axis M7001 Manual de usuario Pagina 7