Axis RightFax 8.5 Guía de instalación descargar pdf (Pagina 21)

RightFax 8.5 Installation Guide 21

15. To enable installation of the RightFax client software FaxUtil and Enterprise

Fax Manager on client computers, share the RightFax folder by entering this

line at a command prompt:

NET SHARE RIGHTFAX=C:\PROGRAM FILES\RIGHTFAX

(Where C:\PROGRAM FILES is the folder where you installed the RightFax

server software.)

Note On Novell networks, the RightFax\Client folder may need to be manually

copied to a NetWare server volume.

Installing the fax board drivers

Regardless of the type of fax boards you use, you must run a separate fax board

hardware driver install program on all computers containing the fax boards after

installing the server. This install program is provided with your RightFax server

software on a separate CD labeled “Fax Board Driver Install.”

Follow these steps to install the fax board hardware drivers. Be sure to run this

installation on all RightFax servers and remote BoardServer machines after

installing or upgrading the RightFax server.

To install the fax board drivers

1. Insert the Fax Board Driver Install CD. If AutoRun is not enabled, run

RightFax\Setup.exe. The RightFax Hardware Module install wizard opens.

2. Click Next at the opening screen to view the RightFax license agreement. You

must accept the license agreement in order to continue the installation.

3. On the Fax Hardware Selection screen, select the type of fax boards you have

installed (Brooktrout and/or Dialogic). If you select Dialogic, specify whether

you have installed the GammaLink CPI or Dialogic DM3 models. Click Next.

4. Click Install to begin the installation.

5. Select the manufacturer and specifications of the installed fax boards. This

step configures one or more of a single type of fax board. If you have more

than one type of fax board installed in your server (i.e., Brooktrout and

Dialogic, or PCI and ISA bus), you must configure the remaining boards after

installation using the BoardServer configuration program (see ”Configuring

the BoardServer” on page 73).

6. When all of the required drivers have been installed, click Finish to complete

the RightFax Hardware Module install wizard.

If you installed drivers for the Dialogic DM3 fax board series, a separate

Dialogic board configuration program will run. For information on

completing this configuration, refer to the documentation included with your

fax board or contact your board manufacturer.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

Sin comentarios

Axis RightFax 8.5 Guía de instalación Pagina 21