Axis BTA 2100D Manual del operador descargar pdf (Pagina 317)

100

101

315

Item Description

microTCD Adjustments in the active method.

Current Displays, in mA, the actual microTCD current.

Balance Pct

Displays, in %, the microTCD bridge balance. On the 3800

GC, the bridge is balanced automatically and should normally

set around 0%. A large offset in bridge balance (+ or -) could

indicate a potential problem.

Polarity

positive or negative

Displays the microTCD Polarity initial condition setting or

time-programmed setting in the active method.

Detector Signal Displays, in mV, the actual microTCD detector signal at the

3800 GC.

Bunch Size Displays the data acquisition bunch size.

Freq Displays the data acquisition bunch rate, in Hz.

FID Status:

Item Description

Ready Yes or No.

The FID detector is Ready (Yes) if the setpoints have been

achieved and stabilized. The FID detector is Not Ready

(No) if readiness to start a run has not been achieved or if,

during a run, the FID detector becomes not ready or goes

“out of tolerance”. Some reasons the GC may go Not

Ready during a run are: the temperature program is too

aggressive, the oven door is opened, the coolant runs out,

the power line voltage drops, etc.

Fault Yes or No.

Displays if a fault in the FID detector component has

occurred.

FID Electronics On or Off

Displays the FID Electronics setting in the active method.

Range 9, 10, 11, or 12

Displays the FID Range initial condition setting or the time-

programmed setting in the active method.

Time Const Fast (50 msec) or Slow (200 msec)

Displays the electrometer time constant setting from the

FID Adjustments in the active method.

Detector Signal Displays, in mV, the actual FID detector signal at the 3800

1 2 ... 312 313 314 315 316 317 318 319 320 321 322 ... 596 597

Comentarios a estos manuales

Sin comentarios

Axis BTA 2100D Manual del operador Pagina 317

Comentarios a estos manuales

Relacionado con productos y manuales para Software Axis BTA 2100D