Axis BTA 2100D Manual del operador descargar pdf (Pagina 366)

100

101

364

Item Description

Runtime Shows the elapsed time in minutes since the beginning of

the run. The maximum run time is 999.99 minutes.

Endtime Shows the time at which the run will end.

State Ready, Running, Stabilizing, Equilibrating, Computing, or

Not Ready

Shows the state of the GC. The light appears green if the

GC is Ready or Running. Otherwise, the light is red.

Fault/No Fault indicator No Fault (green light) or Fault (red light).

When a hazardous or disabling fault occurs, any run in

progress will halt and the affected component will shut

down. If the fault is recoverable, then the run +is not

terminated.

Start If the system is Ready, starts the GC Method and sends

a start signal to the GC. The Start button is disabled

unless the 3900 GC is in the Ready state.

Reset Resets the GC, advancing it to the next state. If it is

RUNNING, the GC aborts the current run, goes to the

READY state, and continues with the next injection in the

Sequence.

Method Opens the Method Builder application for editing the

active 3900 GC method.

Setup Opens the GC Setup Dialog Box which is used to set the

configuration of the 3900 GC.

Extend The Extend runtime button allows the runtime to be

extended by 10 minutes each time the button is clicked

on. The extended run time will be used until the method

is either re-activated or a new method is activated. The

extend run feature does not change the method stored in

your Saturn WorkStation.

Oven Off/Oven On Oven On/Oven Off. Turn the column oven heater either

on or off depending on its current state.

End stabilization If the 3900 GC is in a stabilization state, this button will

end the stabilization time and set the gc to ready.

Temp Zones Status Display

The temperature zones status display is in the middle portion of the 3900 Status

and Control window. The display includes the setpoints and actual temperatures

of the column oven, and the injector of the 3900 GC. The display is “Fault” if a

fault occurs in the zone component or “Off” if the zone oven is off.

The LEDs indicate the status of each temperature zone. If the zone is not

configured or the zone oven is off, the LED is gray. If the temperature zone is Not

Ready or there is a fault, then the LED is red. Otherwise, the LED is green.

1 2 ... 361 362 363 364 365 366 367 368 369 370 371 ... 596 597

Comentarios a estos manuales

Sin comentarios

Axis BTA 2100D Manual del operador Pagina 366

Comentarios a estos manuales

Relacionado con productos y manuales para Software Axis BTA 2100D